• No Adhesive, Bonds Only to Itself
• Withstands +500F (+260C), Remains Flexible to -85F (-65C)
• Forms a Permanent Air & Water Tight Seal
• Incredible 700 PSI Tensile Strength
• Insulates to 8000 Volts layer (20 mil)
• Stretches to 3x's its Length, Conforms to Irregular Shapes
• Resists Fuels, Oils, Acids, Solvents, Salt Water, Road Salt, UV Rays, Weld Slag & Splatter

Pro-Rap™ is suitable for use wherever a tough, high temperature, permanently resilient insulation or seal is required. Properly installed, Pro-Rap™ provides a moisture-free permanent seal around hoses, tubes and wire harness bundles, offering low cost solutions to common problems in extreme environments.

1. Wrap Pro-Rap™ around the item by stretching and overlapping onto itself. Stretch at least double to ensure a good bond; for high pressure leaks stretch to maximum amount. The tighter Pro-Rap™ is wrapped, the faster and stronger the bond will be.
2. Continue wrapping Pro-Rap™ around project by overlapping 50% onto itself so that ½ the width is covered by the next wrap. The first and last wrap should completely overlap onto the previous wrap for a complete bond. Additional layers may be necessary, and the same process should be used over the previous layers. Pro-Rap™ works on either side.
3. Repositioning Pro-Rap™ is only appropriate in the first few seconds after wrapping. Attempting to reposition Pro-Rap™ after 1 minute or longer is not recommended.